MSI MS-6577 CHIPSET DRIVER DOWNLOAD

Skip to main content. Refer to the hard disk documentation supplied by hard disk vendors for jumper setting instructions. Floppy Disk Drive Connector: JSP1 This connector is used to connect the internal speaker if available. I believe it was well worth the few dollars spent. You can connect a network cable to the LAN jack. Mic is a connector for microphones.

Uploader: Mazutilar
Date Added: 13 September 2017
File Size: 15.49 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 28947
Price: Free* [*Free Regsitration Required]

If the CPU is correctly installed, the pins should be completely embedded into the socket and can not be seen.

MSI MS Specifications |

AGP is an interface specification designed for the throughput demands of 3D graphics. Please note that any violation of the correct installation procedures may cause permanent damages to your mainboard. Mount the fan on top of the heatsink.

Mmsi Computer Motherboard for Intel. This item doesn’t belong on this page.

The plastic clip at each side of the DIMM slot will automatically close. X Micro ATX mainboard. It’s a community-based project which helps to repair anything.

The computer was great but the motherboard went south, so I searched for a used motherboard. The number of pins on either side of the breaks are different. Hardware Setup Hardware Setup 2 This chapter provides you with the information about hardware setup procedures.

  CHERRY 91275 DRIVER DOWNLOAD

You can attach a serial mouse or other serial devices to this port. Press the two levers down to fasten Press down the fan until its four clips get wedged in the holes of the retention mechanism. If you install two hard disks on cable, you must configure the second drive to Slave mode by setting its jumper.

JSP1 This connector is used to connect the internal speaker if available.

MSI Ms-6577 Ver 2.1 Socket 478 5187-3670 Motherboard With I/o Plate

These connectors support the provided IDE hard disk cable. It was certainly cheaper than replacing the computer, even if it only continues to work for another year.

Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. You can connect a network cable to the LAN jack. I plugged in all the components from the old motherboard, swapped the processor and memory over and within ms-577 to 30 minutes the computer was operating again.

Connect the fan power cable from the mounted fan to the 3-pin fan power connector on the board. The connector location and pin assignments are as follows: To attach the fiber-optic cable to optical SPDIF jack, you need to remove the plug from the jack first. An operating system that supports HT Technology.

  ASPIRE 4736Z DRIVER DOWNLOAD

Skip to main content.

Always consult the vendor for proper CPU cooling fan. Locate the CPU and its retention 2. Socket F Computer Motherboard for Intel.

I believe it was well worth the few dollars spent. The CPU chipest only fit in the correct orientation. Socket M Computer Motherboard for Intel. That battery has long life time for at least 5 years.

The S-Bracket offers 2 SPDIF jacks for digital audio transmission one for optical fiber connection and the other for coaxialand 2 analog Line-Out jacks for 4-channel audio output.

You can install memory modules in any combination as follows: Pull the lever sideways away from the socket. Then push down the power supply firmly into the connector.