To prevent loss of work and damage to the computer or drive:. By pressing ‘print’ button you will print only current page. Slide the new drive into the hard drive cage 1 , aligning the drive with the four screw holes on the cage. HP in-1 Media Reader. The power cord should always be disconnected before servicing a unit. Heatsink retaining screws should be tightened in diagonally opposite pairs as in an X to evenly seat the heatsink to the processor.
|Date Added:||27 June 2013|
|File Size:||47.71 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Before handling a drive, ensure that you are discharged of static electricity. The computer should automatically recognize the additional memory when you turn on the computer.
If you are adding a second hard drive, connect the data cable to the light blue connector labeled SATA3. Press the card straight down into the expansion socket on the system board. Removing an Internal 3. Remove the two retainer screws that secure dx2180 drive to the bay 1 then dx28810 the drive ex2810 and out of the bay 2. If you are replacing an old drive with a new drive, use the four retainer screws from the old drive to install the new drive.
Technical data is gathered for the products supported by this tool dx28810 is used to identify products, provide relevant solutions and automatically update this tool, to improve our products, solutions, services, and your experience as our customer.
Press the tab on the right side of the switch holder 1 to disengage it from the chassis, rotate the switch to the left 2and then pull it to the right and away from the chassis while guiding the wires through the hole in the chassis.
HP DX2810 MAINBOARD SOCKET 775 REFURBISH (508460-001)
In order to create a dual-channel memory configuration, the memory capacity of Channel A must equal the memory capacity of Channel B. The Virtual Agent is currently unavailable. Reset the date and time, your passwords, and any special system setups, using Computer Setup. Intel Celeron E Processor 2.
HP DX MAINBOARD SOCKET REFU (end 10/26/ PM)
Be sure the side with the access panel is facing up. Hard drives use standard screws. Drivers may be in development so please check back at a later date or visit the product homepage. Slide the drive in through the front of the chassis 1 until the screw holes on the drive are aligned with the screw holes on the drive cage and install the two M3 metric retainer screws 2 as shown in the illustration below.
HP COMPAQ DX QUICKSPECS Pdf Download.
System Fan Prepare the computer for disassembly Preparation for Disassembly. Refer to System Board Drive Connections for an illustration of the system board drive connectors. Nothing herein should be construed as constituting an additional warranty. Remove the optical drive Removing an Optical Drive.
Intel Core 2 Quad Q Processor 2.
The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Remove the four Phillips screws that secure the fan to the chassis, rotate the top of the fan forward, and then remove the fan from the chassis.
Disconnect all power cables from the mass storage devices and from the system board. Do not rely on components like the drive cage, power supply, or computer cover xx2810 push cables down into the dxx2810. If you are inserting or removing a drive, shut down the operating system properly, turn off the computer, and unplug the power cord. Match the notch on the module with the tab on the memory socket.